Operation Regulations for the Steel Bar Cutting Machine Safety

When using a steel bar cutting machine, operators should always pay attention to safety first.

So what are the specific contents of the operation regulations of the steel bar cutting machine safety? Next, TJK MACHINERY (TIANJIN) CO.,LTD brings you an introduction of related contents for reference.

1. The work surface for connecting and feeding materials and the lower part of the cutter are kept level, and the length of the worktable can be determined according to the length of the processed material.

2. Before starting, it is necessary to check that the cutter should be free of cracks, the bolt of the cutter holder is fastened, and the protective cover is firm. And then check the meshing gap of gears and adjust the cutter gap.

3. After starting, have the idle running first, check that all rotating parts and bearings are running normally before operation.

4. When the machine does not reach the normal speed, do not cut the material. When cutting, you must use the middle and lower parts of the cutter, hold the rebar and aim at the knife edge and feed materials quickly.

5. Do not cut rebars whose diameter and strength exceed those specified on the mechanical nameplate and red-hot rebars. When cutting multiple rebars at one time, the total cross-sectional area should be within the specified range.

6. When cutting short materials, the distance between the hand close to the blade and the blade should be kept at least 150mm. If the side of hand gripping is less than 400mm, the short end of the rebar should be clamped tightly with a drivepipe or clamp.

7. It is strictly forbidden to directly clean the short heads and debris nearby by hand during operation, and operators are not allowed to stay around the swing area of the rebar and near the knife edge.

8. The machine must be shut down when faults are found or maintenance is needed, and the power supply should be cut off in advance. After the operation, use rebars to remove debris from the cutter, cut off the power supply, and lock the door.

The above is the operation regulations of the steel bar cutting machine safety. I hope it can help everyone. If you want to know more related knowledge, please visit tjkmachinery-group.com.