What If the Intelligent rebar straightening machine Fails?
In recent years, with the continuous development of processing machinery industry, steel bar cutting, bending, straightening and other steel bar processing machinery have significantly improved the performance and quality of equipment on the basis of traditional technology. Also, new technologies and new products are emerging.
If there is no knife out of the case in the use of intelligent rebar straightening machine, what should we do? Next, our professional after-sales staff will tell you the reason why the intelligent steel straightening machine can't produce the knife and its solutions.
Ⅰ. The reason why the intelligent rebar straightening machine does not produce the knife
The motor does not rotate or reverse; the internal drive shaft is broken; internal claw and pin failure; belt failure (not tensioned, damaged, or with grease).
Ⅱ. The solution of the intelligent steel bar straightening machine does not produce the knife
1. The motor does not rotate or reverses
If the motor of intelligent rebar straightener does not rotate, check whether the motor is damaged and whether there is a circuit problem; Reversal can replace two of the three live wires of three-phase electricity.
2. The internal drive shaft is broken, and the internal claw pin is out of order
The lubricating oil of the intelligent rebar straightening machine needs to be released, and it needs to be disassembled for inspection. If it is damaged, it can be replaced with new parts.
3. Belt failure (not tensioned, damaged, with grease)
Tighten the belt first. If it fails, try to replace with a new belt.
May 20, 2021There is no doubt that the steel bar cutting machine is an industrial equipment used to carry out fixed-length laser cutting production and processing of building steel bars in large and medium-sized ...view
June 21, 2019Manufacture of wire cages 1. Material Requirements: rebar must have the certificate of qualified exit and quality assurance certificate. Rebar should be stacked separately according to specifications,...view
September 4, 20191. Relief method for the failure of the wire straightening and cutting machine starting up normallyWhen the machine has a fault that can only be jogged and cannot be started normally, check the contro...view
January 4, 2021The wooden structure is the mainstream in the Chinese ancient architecture, which has the disadvantages of being flammable, not anti-seismic, vulnerable to corrosion, etc. Therefore, people have inven...view
April 7, 20191. When the stirrup bending machine and straightener are installed together, the centerline of the straightener must be found, and it should be in the same line with the bearing frame on the stirrup bending machine.view