Analysis of the Four Parts of the Rebar Straightening Machine

Rebar is one of the most frequently used auxiliary materials in the construction industry. In construction engineering, rebar will inevitably be straightened, bent, cut and other operations. At this time, the introduction of rebar straightening machine has promoted the field of rebar processing to a brand new high. This article will introduce the four main components of a rebar straightening machine.

1. The rerouting part of the rebar straightening machine

It can realize automatic pay-off without hoisting, and it should be installed about 6-8 meters away from the front end of the rebar straightening machine to ensure sufficient tension and length surplus during the rebar straightening process.

2. The pre-adjustment part of the rebar straightening machine

Mainly rely on 5 sets of vertical straightening wheels to complete the stress relief processing of the rebars supplied from the material rack, so as to achieve the surface rust removal of the rebars. The parts are equipped with wire guide sleeve devices, which are generally pre-adjusted for tightness and stress relief.

3. The straightening barrel part of the rebar straightening machine

Mainly by eliminating stress and advancing the operation of the rebar, the straightness of the rebar can be adjusted at will by using the straightening wheel to support the left and right wires to move forward and backward.

4. The traction and feeding part of the rebar straightening machine

There are one set of active feeding box and passive feeding box, which are assembled behind the turbine shaft of the active box to drive the sprocket and chain of the passive box, thereby driving the passive box behind to complete the entire feeding work before and after straightening.

The above-mentioned four parts play a very key role in the actual application process of the rebar straightening machine, which deserves the attention of relevant application units.