Operation Rules and Matters Needing Attention of Multifunctional CNC Stirrup Bending Machine
With the transformation of China's economy to the market economy, the appearance of automatic numerical control stirrup bending machinesymbolizes that China's industrialization level has taken a big step forward, and it improves the efficiency and wins the favor of construction personnel.
Operation rules and matters needing attention of multifunctional CNC stirrup bending machine:
1. Check whether the mechanical performance is good, and whether the worktable and the bending machine table remain level, and prepare all kinds of mandrel tool stopper.
2. The diameter and the hoop of the rebar should be machined according to the requirements, and the mandrel, the forming shaft, the iron retaining shaft or the variable gear should be installed. The diameter of the core shaft should be 2.5 times of the diameter of the rebar.
3. When inspecting the mandrel, the block and the turntable should be undamaged and cracked, and the protective cover should be tightened and reliable. After the operation of the empty machine, it can be operated normally.
4. During the operation, the bent end of the steel bar should be inserted in the inherent gap of the turntable, the other end should be fixed by the body and pressed with the hand. If the body has been fixed on the side of the bar, we can operate it.
5. It is strictly prohibited to replace mandrel, change angle and speed, and do not add lubricating oil or remove it.
6. When bending the rebar, it is forbidden to process rebar that exceeds the specified diameter, root number and mechanical speed.
7. When bending high hardness or low alloy steel bars, the diameter limit should be changed according to the nameplate requirements and the corresponding mandrel should be replaced. It is widely used: the equipment adopts CNC servo-control system, which can automatically complete straightening, setting, bending and cutting, and can bend the rebar whose diameter is 16mm and produce product of any plane shape continuously.
September 19, 2018Wearing is a common problem of mechanical equipment, of course, the main factor that affecting the normal use of equipment is also the abnormal wearing of equipment parts. In the case of a rebar bende...view
April 13, 2019The steel bar bending machine equipment that has been sealed for a period of time should be maintained once before operation. During the maintanance, the whole machine should be inspected, cleaned, go...view
August 4, 2018After using the wire straightener, the machine's step and work surface should be cleaned up, which is beneficial to the next using process of the wire straightener. There will not be too much deviatio...view
April 4, 2019With the transformation of China's economy to the market economy, the appearance of automatic numerical control stirrup bending machine symbolizes that China's industrialization level has taken a big ...view
November 30, 2018Wire bending machine generally consists of an input and output device, a numerical control device, a programmable controller, a servo system, a detection feedback device, and a machine host.The config...view
November 18, 2018For the user, if he wants a steel truss girder welding machine to bring a satisfactory effect in the actual application, then in the process of selection, we must pay attention to choose the most suit...view