Basic Principle of Reinforcing Cage Forming Equipment and Cage Welding Machine
The working structure of reinforcing cage forming equipment can be divided into three parts: control system, drive system, traction system, and a welding feed system. The main function of the control system is to control the beginning and end of the work of the reinforcing cage welding machine and the supply of the electric motor force. The main function of the drive system is to synchronize the rotary movement of the fixed disc and the moving disk, so as to realize the winding action of the stirrups on the main reinforcement. The main function of the traction system is the linear reciprocating motion of the sprocket wheel on the chain track,
coordinate with the rotating movement of the moving disc to realize the formation of the actual distance between the hoop tendons wound on the main bars. The main function of the welding feed system is to realize the moving feed between the welding machine and the welding head to complete the corresponding welding action of the welding device.
The basic principle of the reinforcing cage welding machine is that the control system sets the distance between the stirrups around the main reinforcement and the length of the steel cage in advance. The main bars are installed between the fixed disc and the moving disc and fixed clamps, and the rotary between the moving disc and the fixed disc is synchronized, the stirrups are wound through the straightening wheel parts to the main bars, and then the control signal is transmitted by the system control device.
At the intersection point between the stirrups and the main reinforcement, the moving welding device is used to track the moving solder joints at the intersection point, the compression wheel rolls over and compacts the stirrups to realise the required polygon, at the same time, complete the whole welding operation of the welding device with the welding torch, the traction sprocket belt rotating moving disc along with the main working tendon to do auxiliary linear motion, and finally complete the forming of the whole reinforcing cage.
August 11, 2020Reinforced mesh, also known as welded steel mesh, is a kind of mesh that the longitudinal reinforcement and transverse reinforcement are arranged at a certain distance and form a right angle to each o...view
November 29, 2021The application of steel bar bending machine is very extensive. It can be said that it is often used especially in the field of steel and construction. It has a lot of performance, good bending effect...view
September 4, 2018Rebar sawing and thread polishing line is a necessary rebar processing equipment, such as rebar bender and cutter for large rebar processing enterprises.view
September 4, 20191. Relief method for the failure of the wire straightening and cutting machine starting up normallyWhen the machine has a fault that can only be jogged and cannot be started normally, check the contro...view
August 2, 2018Our company's wire straightener has a more reasonable structure design comparing to other straightening equipment, the style is more novel with no need to emphasize.view
January 11, 2022The steel bar straightening machine is used to straighten the steel bars. Take a model with eight orthodontic wheels as an example. The four wheels in the middle are responsible for straightening, and...view