Brief Discussion on Operation Flow of Steel Wire Straightening Machine
Steel wire straightening machine is a straightening equipment for metal profiles, bars, pipes, wires, etc. The steel wire straightening machine changes the straightness by extruding the bar with straightening roller.
Generally, there are two rows of straightening rolls with different quantities Everyone has a simple understanding of the wire straightener, so let's talk about its operation process.
1.before starting the machine, first check the hydraulic oil, reduction gearbox and transmission gearbox of the hydraulic station to see if their gear oil is full. Before the main motor of the steel wire straightening machine is started, the inspection of the angle and the working pressure of the hydraulic system must be adjusted.
2.When the lubricating oil is injected into each lubricating point, the operation of the rotating part of the machine must be checked to make it operate flexibly. During the operation, the operator must first wear labor protection articles. If the steel wire straightening machine is started, it is not allowed to leave the post or carry out the cross post.
3.After stabilizing the oil temperature and oil pressure of the hydraulic station, lift up the upper straightening roller, and then place it at the beginning. After receiving the material manually, the steel pipe is sent to the third pair of straightening rollers, and then the upper straightening roller is pressed down and clamped. When it is started, what is straightened at the same time is the forward direction of the steel tube rotation.
4.After the motor of the main motor is stopped, the straightening work of the straightening roller is also stopped, and the straightening roller is lifted up, and then the straightening steel pipe is sent out. If the steel wire straightening machine wants to reverse straightening, the reverse knob can be used on the operating platform to reverse the main machine, and then carry out the opposite straightening. When the main motor stops, the straightening work of the straightening roller stops, and the steel pipe retreats to the initial position, and then wait for repeated instructions to carry out the next straightening procedure. If the machine is stopped, turn off the main power supply and do not change the controller of the program.
Our steel wire straightening machine is very valuable, very recognized by everyone. If you still have any questions about us, you are welcome to consult us.
October 13, 2018Rebar bending machine is one of the steel processing machinery. The working mechanism is a horizontal working disk that rotates on the vertical axis, and we should place the steel bar in the position ...view
February 25, 2020I.shear installation and test run of rebar shear1.Rebar shear machine shall be installed on flat and solid ground.2. When installing the bearing frame, the center of the bearing frame material groove ...view
May 31, 2019The safety operation rules for wire cage welding machineWire cage welding machine and pipe pile rolling welder belong to large-scale mechanical equipment. In the daily operation process, we must opera...view
June 12, 2019Daily maintenance of equipment is an important link to ensure the normal operation of equipment and prolong its service life, which can not be ignored. The main contents are as follows:1. Keep the equ...view