How Do Newcomers Quickly Master the Operation of Stirrup Bending Machine
Many manufacturers of steel bar hoops need to use the
Many manufacturers who process the stirrup bending need to use the stirrup bending machine. For those newcomers who have just come into contact with this device, it will take some time to use it well veritably in the face of such a complicated device. So how to quickly master the operation of the steel bending machine as a novice?
First of all, from the work assignments that go to work after work, we must pay attention to the matters and measures at the time of handover. After careful trial operation, only if there is no abnormal situation that can be processed. There should be no obstacles in the operation site and the swinging range of the hoisting arm. The dangerous area should be demarcated, no idlers should be allowed to enter, and the guards should be sent. The slewing sirens, rearview mirrors and side mirrors should be intact, and the turret guardrails should be intact.
Secondly, the ground of work site should be selected as solid as possible. When working on the soft ground, the board should be covered with wooden boards or sleepers under the legs. The crawler crane should be padded with sleepers to prevent from sinking. Do not move during the process, the wheels must be taken care not to slip.
In particular, it should be noted that the coolant of the stirrup bending machine should not be replaced with fresh water. With the temperature rising again gradually, some guys find that the coolant in the water tank is insufficient, and they just refill it with fresh water randomly. At this time, the car antifreeze is not the subject, but the water is easy to produce water alkali, water rust, and the boiling point is low, which is easy to cause "opening." Therefore, the coolant cannot be exchanged for clean water at will. At the same time, when changing the coolant, check whether the left and right drainage holes are blocked, so as to prevent the rainwater from being discharged after the rain, and pour into the vehicle.
The above points are to help the novices quickly master the operation of the steel bending machine, hope that everyone can read it carefully.
November 27, 20181. The section which from 200mm to 250mm is checked on the metal wire and the surface of the wire must not be damaged when straightening.2. There are four vertical holes on the main pulling rod. The h...view
June 12, 2019Daily maintenance of equipment is an important link to ensure the normal operation of equipment and prolong its service life, which can not be ignored. The main contents are as follows:1. Keep the equ...view
November 12, 2018In many engineering fields such as construction, bridges, fire protection, steel, etc., there is a working procedure called steel prestressing. The traditional method is to cut the steel wire by manpo...view
March 14, 2019(1): The working surface of the feeding material should be kept at the lower part of the cutter, and the length of the worktable can be determined according to the length of the processing material.(2...view
August 26, 20181. Transportation of reinforcing cage welder Horizontal transportation of reinforcing cage uses flat plate car, and fasten the reinforcing cage to narrow fastening. The crane is vertical transport, a...view
May 13, 2019Truss Girder Welding Machine SummaryMore and more building structures are used in the structure of the steel truss, especially the special type steel frame used in the stadium, exhibition hall and oth...view