Analysis of Five Parts of Rebar Straightening Machine

Steel bar is one of the most frequently used auxiliary materials in the construction industry. In construction engineering, steel bars will inevitably be straightened, bent and cut off. At this time, the introduction of rebar straightening machine promoted the field of steel bar processing to a brand-new height. This article will introduce you to the five main components of rebar straightening machine.

1. Rerouting Part of Rebar Straightening Machine

It can realize automatic setting-out without hoisting. It should be installed about 6~8 meters away from the front end of rebar straightening machine to ensure that there is enough tension and length margin in the process of steel bar straightening.

2. Pre-Adjustment Part of Rebar Straightening Machine

It mainly relies on five sets of vertical straightening wheels to finish the stress relief treatment of steel bars supplied from the material rack, so as to achieve derusting on the surface of steel bars. This part is equipped with an incoming guide sleeve device, which generally completes pre-adjustment work of tightening and stress relief.

3. Straightening Barrel Part of Rebar Straightening Machine

It mainly relies on relieving stress to promote the running of steel bars. The straightness of reinforcement can be adjusted at will by using the forward and backward movement of the left and right wires of the straightening wheel bracket.

4. Traction Feeding Part of Rebar Straightening Machine

It mainly includes one set of active feeding box and one set of passive feeding box. It is assembled behind the turbine shaft of the driving box to drive the sprocket and chain of the driven box, thus driving the driven box behind to complete the whole feeding work before and after straightening.

The above four parts play a key role in the practical application of rebar straightening machine, which deserves attention from relevant application units.