The Use Strategy of Wire Mesh Welding Line Machine

First, the operator must be familiar with the welding principle of thewire mesh welding line machine, the use of each control button, and then achieve the following two points:
1. Be sure to read the product manual carefully.
2. In the process of using the machine after installation and debugging, it is necessary to carefully check whether each part of the machine is in good condition.

Operation flow of wire mesh welding line machine
1. Before use, make sure that the plug of control board must be plugged and fastened;
2. The outer shell of the wire mesh welding line machine must be reliably grounded, and the welding machine shall not be affected by moisture;
3. Adjust the secondary voltage according to the thickness of welding parts, and the indicator light should be on when the power switch is turned on;
4. Step on the pedal, the contactor is absorbed, and control welding time, that is, the welding process can be completed, and spot welding and multi-point simultaneous welding can be completed;
5. Do not touch the contact with your hand to avoid electric shock and shock.
6. After each operation, the photoelectric machine head should be repaired in time;
7. After each work, check whether the machine head, spring, lever group and foot are damaged and loose, and restore and repair in time;
8. Check the electrical control components after the completion of each work order to see if they are effective. If there is any damage, replace and repair it in time;
9. Repair mechanical transmission parts on the day of damage. Communicate with manufacturers to repair as soon as possible
10. When using power, it is not allowed to open the control box housing, let alone touch all parts of the box by hand to avoid electric shock (high pressure of 380V inside the box).
11. Make sure to cut off the power supply when checking internal connection and control board connection.
12. Do not touch the components on the control board by hand, or there may be static electricity damage to the components.
13. The potentiometers on the control board have been adjusted. Please do not move.
14. The control box should be connected with cooling water before use, and sufficient flow and pressure of cooling water should be ensured. The water cooling system should be checked regularly (once a month). The running water should be kept clear and watertight.
15. Check the wiring in the box regularly (once a month).