What Are the Reasons that Affect the Efficiency of Rebar Cutter?
It is well known that rebar bender and cutter are designed to cut off all kinds of round steel, thread steel fixed-length cutting operation is a very typical rebar processing equipment. It is widely used in all kinds of engineering, building, bridge, tunnel, power station, large water conservancy and so on. It plays a very important role in the processing of rebar prestressing force. But sometimes in the use of rebar cutter, there will be low cutting efficiency, so what is the cause of the low efficiency of rebar cutter?
First of all, in the process of normal construction, some enterprises still inevitably have some phenomena of mechanical vacant, technical interruption and reasonable discontinuation, which naturally lower the operating efficiency of the equipment, and the necessary spare shifts often cause unused classes. If the process meets some unfavorable weather conditions, the relevant operators will also affect the efficiency of the equipment when troubleshooting.
Besides, the time required for the mechanical transfer of mechanical transfer in the construction site and of the self type mechanical transfer, the time lost and the time required for the extra fixed distance of the parking lot to the working place, the poor efficiency caused by the conditions at the beginning of the construction and the loss of the amount of the project at the end of the construction. Interruption of operation due to the power supply, water supply failure, and maintenance of hydropower lines. These can also lead to the reduction of the efficiency of the rebar cutter.
In addition, rebar cutter machine produced by different manufacturers also has a difference in the structure and performance, which will lead to a difference in performance of some equipment in the processing of rebar. If the performance is poor, the corresponding equipment operation efficiency will be a little lower, otherwise, it will be higher.
In view of the above reasons for reducing the efficiency of the rebar cutter machine, the industry is constantly improving and making innovation and progress. Rebar cutter machine equipment of the cast rebar body is introduced. In the frequent cutting operation, the metal is heated to produce a series of various influence efficiency problems, and the rebar cutter machine's shell is mixed with rare earth. And manganese alloy, greatly enhance the toughness and wear resistance of the body, allowing the whole machine to run for a long time of high efficiency.
November 3, 2018Rebar cutting machine is a kind of tool used for shearing rebar. Generally, there are automatic steel cutting machines and semi-automatic steel cutting machines. It is a steel processing equipment and...view
October 28, 2018With the development of science and technology, new products of high technology are emerging in many industries. The rebar bending machine is simple to use and easy to operate. But any engineering equ...view
November 21, 2018Main Test Steps:1. The section which from 200mm to 250mm is checked on the metal wire to be calibrated and the surface of the wire must not be damaged when straightening.2. The radius of the clip is R...view
October 16, 2018Rebar bending machine is as important as rebar bending machine. Rebar bending machine is specialized in producing steel mesh machine and is produced by wire mesh machinery factory. Steel mesh is made ...view
September 5, 2017Technology Announcement of The Promotion and Application of Green Construction(draft) On the basis of the regulation on new technology application and administration promotion of construction field (...view
September 22, 2018The function of the hand-held rebar cutter is to supply the gap of the construction machinery industry and the market that full of large machinery. It is difficult to cut the rebar with large machines...view