Installation and Commissioning for the Experimental Equipment of Standard Wire Bending Machine

Purpose: The bending machine is used to test the repeated bending properties of metallic material which its diameter is 3-8 mm and show its defects. Repeated bending machine, which also named standard wire bending machine.

The Main Parameters are as Follows:
Wire Diameter: 3.0 5.0 6.5--8 Radius of Circular Arc (mm): 10 15 20
Distance (mm): 35 50 75
Pull Rod Diameter (mm): 3.5 and 4.5  5.57 and 9
Repeated bending machine, which also named standard wire bending machine.

Installation and Commissioning: The machine should be installed at the edge of the c, and the rotating handle should be extended beyond the worktable. And three M8 bolts should be installed, and there are 10 holes on the bottom plate between the two clips. Worktable should also be drilled to allow the wire to pass freely through the hole. Wire bending machine is special equipment for carrying out positive and reverse bending tests. The main technical parameters and indexes of the equipment meet the requirements of GB5029-85 steel bar plane reverse bending test method.

This product is widely used in steel factories and construction companies to test the positive and reverse bending properties of the screw steel. The machine is the substitute products of the original GW-2/25 and GW-2/40 products, through replacing the accessories with different specifications, the functions of one machine can replace the functions of the two machines, and the resources can be maximally saved. This equipment has complete performance and easy operation. Especially the design of the limit and vulnerable parts is more reasonable, and the wearing parts are easy to be replaced, so the service life is long.