1. According to the specific conditions of the truss, first of all, it should be decomposed into several parts as far as possible and processed and welded in the inner field by truss girder welding machine. After it is completed, it will be transported to the truss for site assembly and welding.
2. In the process of assembly and welding, we should minimize the formation of internal stress and reduce welding distortion. According to the analysis of the drawings, the process should be formulated according to this principle. If welding current is properly controlled, it must not be too large. The weld seam can be prevented according to the requirements of drawings. Internal stress and deformation are two contradictory things, if the rigidity is not large, we should focus on the control of small deformation (generally as the focus). If the rigidity is large, the stress in the assembly welding process should be mainly controlled.
3. The truss is a stress structure. For this reason, we slways use DC welding high quality electrode and reverse polarity connection.
4. Before welding, we should remove rust, remove oil, remove moisture, and bake as required. There are many fillet welds in the truss. The butt welds must be open and double sided to ensure achieve the goal of penetration and increasing height.
June 12, 2019Daily maintenance of equipment is an important link to ensure the normal operation of equipment and prolong its service life, which can not be ignored. The main contents are as follows:1. Keep the equ...view
April 7, 2019Installation steps of stirrup bending machine:1. When the stirrup bending machine and straightener are installed together, the center line of the straightener must be found, and it shoule be in the sa...view
August 26, 2019It is well known that the wire straightener plays an important role in the building construction sites. Therefore, almost every building construction site now has a wire straightener, and some even ha...view
May 16, 2019More and more building structures are used in the structure of the steel truss, especially the special type steel frame used in the stadium, exhibition hall and other large architectural structures, w...view
September 1, 2019Common problems of wire straightening and cutting machine and corresponding solutions(1) There is a solution to the problem that the steel bars cannot be straightened.The processed steel bars are unth...view
September 1, 2017Malaysia has become the preferred place for Chinese enterprises to "go out" in Southeast Asia. With the overall strategy for the development of the national "One Belt And One Road", and the central go...view