Detailed explanation of the working principle of the wire mesh welding machine
The daily circuit is closed so that the entire closed circuit and the current are equal everywhere; but the resistance in each place is different, especially the maximum resistance at the unfixed contact, which is called the contact resistance in physics. According to the law of thermal effect of current (also called Joule law), Q=I^2; X Rt, we can know that the higher the electric current is, the higher the heat of the part of the resistance is. When the stigma is pressed together with the longitudinal and transverse diameters, a great deal of heat will be released, which makes the longitudinal and transverse diameters dissolve and bond instantaneously.
How to use wire mesh welding machine correctly?
1. Wire mesh welding machine can be welded after water. The moving parts of the welding machine should always be lubricated, and the welding parts should be welded after cleaning to avoid damaging the electrode or affecting the service life of the welding electrode.
2. When the wire mesh welding machine works at temperatures below zero degrees Celsius, the compress air should be blown off the cooling water left in the cooling pipe after welding, so as to avoid freeze cracking and freezing damage of the pipe and welding transformer.
3. Wire mesh welding machine should be repaired and maintained after power failure. Operators should wear canvas gloves and girth to avoid scalding.
4. The wire mesh welding machine can not be dampened to prevent leakage. The insulation resistance of the welding machine which is not used for a long time should be checked before using. The insulation resistance between the power input line and the outer shell of the welding machine should be tested by 500V Megohmeter before being energized.
5. There should be no corrosive gases, chemical deposits, corrosive, explosive and flammable media which can seriously affect the insulating performance of the welding machine.
6. The wire mesh welding machine should work strictly in accordance with the rating of the rated load, and the overload is not allowed.
7. The water distributor filter of air source treatment device must be drained frequently. The water level should not exceed the warning line. Otherwise, the water-bearing compressed air will enter the oil mist and solenoid valve cylinder, and it may cause the cylinder of solenoid valve to wear faster and even can not work normally.
March 23, 2019The rebar cutting machine is a steel processing equipment, mainly used to cut the rebar material, so as to get the steel that can be used. In general, the steel is produced in a unified standard, thes...view
September 1, 2017Technology Announcement of The Promotion and Application of Green Construction(draft)On the basis of the regulation on new technology application and administration promotion of construction field (Th...view
October 22, 2018The rebar bending machine mainly carries out bending work of rebar to meet the work demand. There are many rebar bending machines on the market, and they have different brands, different models, and d...view
March 14, 2019(1): The working surface of the feeding material should be kept at the lower part of the cutter, and the length of the worktable can be determined according to the length of the processing material.(2...view
September 10, 2018The following are the practical maintenance methods for rebar bender and cutter.Rebar cutter is a kind of machine used in building construction site, it is also a kind of cutting machine which is ofte...view
July 27, 2018According to relevant statistics, the wire straightening and cutting machine made in our homeland occupies a dominant position in the domestic market, the marketing share has reached more than 80%. At...view